Kodak Printe Manual de usuario Pagina 32

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 60
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 31
Installing additional memory A-2
VinylJet 36
TM
Reference Guide
To remove the SIMMs
1 Facing the top of the SIMMs, push the side
clips gently to the outside (away from the
SIMM).
2 Push over and pull out, being careful not to
damage the fingers on the top.
To install the new SIMM
1 Insert at a 45 degree angle and slowly push the SIMM to a 90
o
angle until the
two side clips snap into place. Make sure the SIMM is fully seated.
2 Carefully reconnect the ribbon cable harness to the connector on the PC
board. Reattach the other connectors removed earlier.
3 Reinstall the right cover and top cover.
Vista de pagina 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

Comentarios a estos manuales

Sin comentarios